Is there a fuel reset on a 2000 Chevey selverido?

The Chevrolet Silverado truck has a fuel pump reset switch that can be found on the toe board of the vehicle. This is somewhat easy to locate. ... The fuel pump reset is snugly positioned in the passenger footwell.

1. Where is the fuel pump reset switch located?
2. How do you reset the computer on a 2000 Chevy Silverado?
3. How do I reset my fuel inertia switch?
4. Where is the fuel pump reset switch location on the Chevy Silverado?
5. How do you reset the fuel pump sensor?
6. How do you reset a PCM on a Chevy 1500?
7. How do you reset the computer on a Chevy Silverado?
8. What is the fuel pump reset button for?
9. Where is the fuel pump control module?
10. How do you reset ECM on GMC?

Where is the fuel pump reset switch located?

The fuel pump shut-off switch is located behind an access panel on the right side of the luggage compartment. The fuel pump shut-off switch has a red reset button on top of it.

How do you reset the computer on a 2000 Chevy Silverado?

To reset the computer in a 2000 Chevy Silverado, remove the nut from the negative battery cable using a socket set or wrench. Slide the cable off of the battery and set it aside. Turn the headlight switch to the "On" position to drain the ECM of any remaining power.

How do I reset my fuel inertia switch?

Press down the rubber reset button on the top of the inertia switch. 3. Turn the ignition switch to position 'II', pause for a few seconds, then return the key to position '0'.

Where is the fuel pump reset switch location on the Chevy Silverado?

The fuel pump reset switch can be found on the toe-board, to the right of the transmission hump, in the passenger-side footwell.

How do you reset the fuel pump sensor?

Turn the ignition switch to the "On" position. Hold the "Odo/Trip" button for two seconds. Release the "Odo/Trip" button and then immediately press it again, release it, press it, release it and then press it and hold it. Hold the button until the leveling information is displayed on the odometer, about five seconds.

How do you reset a PCM on a Chevy 1500?

To reset the pcm on a chevy silverado you will need to remove the battery cable for about 10 minutes to allow the system to reset.

How do you reset the computer on a Chevy Silverado?

Remove the nut off the negative battery cable with a socket set or wrench. Slide the cable off of the battery and put it aside. Turn the headlight switch to the "on" position to drain the ecm of any remaining power. Wait at least 10 minutes, then turn it back to the "off" position.

What is the fuel pump reset button for?

In the event of an accident, the "Fuel Reset Button" will turn off the fuel pump and system.

Where is the fuel pump control module?

The module is typically installed on or very close to the fuel pump, and in the early years of the component's use, this practice led to a design fault. Manufacturers, including Ford, initially placed the module inside the vehicle immediately above the fuel pump, typically just beneath the floor pan.

How do you reset ECM on GMC?

When this stored content causes problems, a reset of the ECM is in order. Momentarily cutting the system off from its power source is all that's required to force a reset. All codes will be erased, and the ECM will start from a clean slate.